User's Manual

W W W . D A N G E R O U S P O W E R . C O M

52 53

MAINTAINING THE RAMMER

1. Locate bolt and bolt pin at the back of the marker.

2. Pull bolt pin up and slide bolt out of marker. 

3. Use allen wrench (5/32”) turn counterclockwise to

remove the Ram Cap. 

4. Remove the Ram cap from marker. 

5. Remove the Ram and Ram spring. 

MAINTAINING THE RAMMER (CONTINUED)

6. Wipe off all visible debris and grime from the Ram and

Ram spring with a soft dampened cotton cloth and

cotton swab. 

7. Lightly apply DP-40 lubricant to the tip of a cotton swab

and apply lubricant on the o-rings located on ram.



8. Apply lubricant to the spring on the Ram. 

9. Apply lubricant to the o-ring located on the Ram Cap.



10. Reassemble Ram, Ram spring and back cap in reverse

order.

WARNING

NEVER USE FORCE DURING DISASSEMBLY OR

REASSEMBLY. ALWAYS SEEK ASSISTANCE FROM A

QUALIFIED AIRSMITH OR CONTACT DP ENGINEER-

ING CUSTOMER SERVICE IF YOU ARE UNCERTAIN

OF ANY INSTRUCTIONS DESCRIBED IN THIS

MANUAL.