User's Manual

W W W . D A N G E R O U S P O W E R . C O M

44 45

CLEANING THE BALL DETENTS

The ball detents should be inspected during the cleaning of the

eye sensors. Replace these parts should you notice any

damage, no matter how slight.

1. Locate the eye cover plates on either side of your FX

body.

2. Using provided allen key wrench (5/64”), carefully remove

the eye cover screw on one side by inserting ball point tip

and turning wrench handle counterclockwise.



3. Place nger within breech, and gently push on the detent

from the inside of marker body. Remove ball detent.



4. With a cotton swab, clean ball detent, and detent groove.



5. Replace detent back to original position, with the circular

side down towards the breech.

6. Replace eye cover plate in original position and gently

tighten eye cover screws clockwise. DO NOT

OVERTIGHTEN! 

7. Repeat the same procedure on the other side.

OPERATING PRESSURE REGULATOR (OPR)

DISASSEMBLY AND MAINTENANCE

As its name implies, the OPR regulates the amount of air-ow, which determines paintball velocity. Regular

inspection and cleaning of your OPR is an essential part of keeping your FX running in top condition. Follow the

easy steps outlined below to ensure that your OPR remains trouble-free.

GENERAL DISASSEMBLY OF OPR

1. Before disassembly of your regulator, be sure to

disconnect the macro-line hose from the elbow tting

attached to your regulator. This is accomplished by

pulling back on the collet of the elbow tment, while

simultaneously pulling the macro-line out to remove.

2. With a rm hold on the Ragulator Body, unscrew by hand

the entire unit in a counterclockwise direction. If the OPR

unit is difcult to turn by hand, a rubber strap wrench

available in most hardware stores may be used.



NOTE

DO NOT UNSCREW BY USING WRENCH OR

PLIERS, AS DOING SO MAY SCRATCH AND

DAMAGE THE ANODIZED SURFACE.