User's Manual

32
enter setup mode: The gateway for programming the d-box
+
. Identical to pressing and holding the usb and aes/spdif setup buttons
simultaneously in the
ctrl room section on the unit or in the control room app page. See previous sections for further
explanation.
enter dim amount: Opens the volume app page. See sections on dim for more details.
set reference level: This function defaults to off. To turn it on select . Next, press and hold the mono 7-8 button
until it lights bright amber. Now
is active on your device (bright font, not dark). Navigate to
the
volume page and you will see a new notice beneath the dim button . Tap the dim button twice. The
button will flash amber rapidly. Select your custom reference on the volume control. To commit, press the
dim button.
To exit setup mode, navigate to the control room page and click on either the usb or aes/spdif button. Now when on
the
volume page, the orange
message will turn green when at your reference level. To
disable the
set reference level functionality, simply go into setup mode by selecting from the more
page and pressing and holding the mono 7-8 button until the amber LED turns off. Now exit setup mode by navigating to
the
control room page and clicking on either the usb or aes/spdif button. is now inactive on
your device (darker font).
Tip: , Set your reference level to an Equal Loudness Curve (the artist previously known as Fletcher-Munson). In other words,
use an SPL meter or phone app to set your volume near 85dB. This is where our ears frequency response is the flattest.
Track and mix where you’re comfortable (hopefully at lower levels), then check your mix periodically at the 85dB setting.
On the unit, push the volume knob twice to return to your set reference level. In the app, just hit the tap the dim button
twice.
scan and select d-box+: Locates and connects with your d-box
+
via bluetooth. This only connects for remote control functionality.
Not audio. See section 42. bluetooth audio & remote control setup for more details.
launch device settings app: This shortcut opens the settings page on your device to allow the use of its internal microphone as a
talkback mic and playing back bluetooth audio. Refer to sections 22 & 45. talkback mic for more details.
launch device music app: This shortcut opens the music player on your personal device, for example, iTunes.
disable d-box+ bluetooth: This turns off the bluetooth enable button, thus disengaging both bluetooth audio and bluetooth remote
control. Since bluetooth is now disabled, to reconnect, you will have to manually select the button on the front panel.
disconnect bluetooth audio: Disconnects your bluetooth audio connection between your device and the d-box
+
with a simple button
press. Perhaps you want to give talkback or streaming control to the self-proclaimed record “poducer” (you get the “R”
when you’ve arrived) or you need to use your wireless earbuds to call your Great Aunt Baroness Evelyn Lickspittle or you
simply want to stream to any other device and not have a conflict between warring bluetooth factions.
preferences: automatically searches for the d-box
+
and connects bluetooth for remote control.
Implements a physical sense like vibration to communicate an action has transpired.
For example, selecting a button will cause a quick clunk like sensation. (Only available on iOS devices with Haptic
Feedback Enabled).
If the app is in the foreground, it will remain live on your screen, regardless of sleep or
energy saving settings.
Allows your device to be used as a talkback mic. This is in required and does not
supersede the launch device settings app, you must activate both.
talkback mic level.
If you have more than one d-box
+
, (singer-songwriter suites, for example) select the
preferred device and it will lock to that specific one.