Specifications

The REMOTE jack hooks up to the
remote with shielded CAT 5-e cable that
can be up to 100 feet long. Don’t plug
this into a router or computer. It is not an
Ethernet connection. An RJ-45 jack was
used because this allows one to get cable
and extensions without a fuss. Please use
shielded Cat 5-e cable and connectors.
The TB Remote connector fires the
talkback circuit if pin 2 is connected to
pin 3. Putting a switch on the end of a
mic cable can give someone else in the
control room the means to operate the
talkback circuit. Using the TB Remote
does not dim the control room speakers.
The Cue Amp Out is wired:
Pin 1 common ground
Pin 2 Right amp
Pin 3 Left amp
‘D’ connector pin out
pin # Channel signal
1 8 high
14 8 low
2 8 shield
15 7 high
3 7 low
16 7 shield
4 6 high
17 6 low
5 6 shield
18 5 high
6 5 low
19 5 shield
7 4 high
20 4 low
8 4 shield
21 3 high
9 3 low
22 3 shield
10 2 high
23 2 low
11 2 shield
24 1 high
12 1 low
25 1 shield
13 not used
SR-ST linked together
The Cue Amp Out jack is compatible with several passive headphone level control
boxes from Redco, Whirlwind, ProCo, and others.
-6-