Service manual

8.4.9 DC Bus Bar Assembly
1. Remove 2 screws (T30) from each of the 2
snubbers.
2. Remove the snubbers.
3. Loosen and remove the 2 cables from bus bar
assembly and DC coil.
4. Remove 2 screws (T30).
5. Remove 8 screws (T20) on top of the bus bar
assembly.
6. Remove the bus bar assembly.
Reinstall in the reverse order.
130BC080.11
1
Illustration 8.32 DC Bus Bar Assembly
1 Bus bar assembly
Table 8.32
8.4.10
Heatsink Fan Assembly
1. Remove 4 screws (T20) from the heatsink fan
assembly.
2. Push the cables down through the gaskets.
3. Carefully press the gaskets down with a
screwdriver.
4. Remove the fan assembly.
Reinstall in the reverse order.
130BC094.11
1
2
Illustration 8.33 Heatsink Fan Assembly
1 Fan cover plate
2 Heatsink fan
Table 8.33
I-Frame Size Disassembly an...
VLT
®
HVAC Basic Drive Service Manual
MG90X202 - VLT
®
is a registered Danfoss trademark 93
8 8