Service manual

8.4.7 Relay Transducer Card

1. Remove 2 screws (T20) from each of the 2 cable

connectors.

2. Remove the cable connector.

3. Remove 3 screws (T20) from the support bracket.

4. Loosen the 3 cables (T30) from the relay

transducer card.

5. Unplug all other cables from the relay transducer

card.

6. Remove the 3 screws (T20).

7. Remove the relay transducer card.

Reinstall in the reverse order.

130BC075.11

Illustration 8.30 Relay Transducer Card

1 Relay transducer card

Table 8.30

8.4.8

Terminal Plate

1. Remove 4 screws (T20) on the cover plate.

2. Remove the complete terminal plate including

cable connector.

Reinstall in the reverse order.

130BC078.11

Illustration 8.31

1 Terminal plate

Table 8.31

I-Frame Size Disassembly an...

VLT

HVAC Basic Drive Service Manual

92 MG90X202 - VLT

is a registered Danfoss trademark