Service manual

8.4.5 Bus Bar
1. Unplug and remove the red/black cable.
2. Remove the black plastic cover.
3. Remove 6 screws (T20) and 2 screws (T30) from
the support bracket.
4. Remove the bus bar assembly.
Reinstall in the reverse order.
130BC073.11
1
Illustration 8.28
1 Bus bar
Table 8.28
8.4.6
RFI Filter
1. Unplug the 3 filter cables from the thyristors
using a hex 8 key.
2. Loosen the 3 cables from the cable connector
using a hex 5 key.
3. Remove 3 screws (T20) from the support bracket.
4. Remove support bracket.
5. Remove 4 screws (T20) from the RFI Filter.
6. Remove the entire assembly.
Reinstall in the reverse order.
130BC076.11
1
Illustration 8.29
1 RFI filter
Table 8.29
I-Frame Size Disassembly an...
VLT
®
HVAC Basic Drive Service Manual
MG90X202 - VLT
®
is a registered Danfoss trademark 91
8 8