Service manual

8.3.11 Heatsink Fan Assembly
1. Remove gate cables from IGBTs.
2. Remove 2 screws (T20) from the heatsink fan
assembly.
3. Push the fan cable down through the gasket.
4. Carefully press the gasket down with a
screwdriver.
5. Remove the fan assembly.
Reinstall in the reverse order.
130BC350.10
1
2
Illustration 8.19
1 Fan cover plate
2 Fan assembly
Table 8.19
8.3.12
Capacitor Bank
1. Remove 4 screws (T20) from each of the
capacitors.
2. Remove the capacitors.
Reinstall in the reverse order.
130BC081.11
1
Illustration 8.20 Capacitors
1 Capacitors
Table 8.20
I-Frame Size Disassembly an...
VLT
®
HVAC Basic Drive Service Manual
86 MG90X202 - VLT
®
is a registered Danfoss trademark
88