Service manual

8.3.9 Terminal Plate
1. Remove the black plastic cover.
2. Remove 4 screws (T20) on the cover plate.
3. Remove the terminal plate.
Reinstall in the reverse order.
130BC078.11
1
Illustration 8.17
1 Terminal plate
Table 8.17
8.3.10
DC Bus Bar Assembly
1. Remove 2 screws (T20) from the 2 snubbers.
2. Remove the snubbers.
3. Loosen and remove cables from bus bar assembly
and DC coil.
4. Remove 6 screws (T20) from the bus bar
assembly.
5. Remove the bus bar assembly.
Reinstall in the reverse order.
130BC080.11
1
Illustration 8.18 DC Bus Bar Assembly
1 DC bus bar assembly
Table 8.18
I-Frame Size Disassembly an...
VLT
®
HVAC Basic Drive Service Manual
MG90X202 - VLT
®
is a registered Danfoss trademark 85
8 8