Service manual
8.3.7 Relay Transducer Card
1. Remove the 3 clamps on each side of the 2 cable
connectors.
2. Remove the cable connector with no cables
attached.
3. Remove 3 screws (T20) from the support bracket.
4. Loosen the 3 cables from the relay transducer
card.
5. Remove the cable connector with cables and
retaining guide attached.
6. Unplug all other cables from the relay transducer
card.
7. Remove the 3 screws (T20)
8. Remove the relay transducer card.
Reinstall in the reverse order.
130BC075.11
1
Illustration 8.15
1 Relay transducer card
Table 8.15
8.3.8
Fan
1. Remove 2 screws (T20) on the fan bracket.
2. Remove 2 screws (T20) from the fan.
3. Remove the fan.
Reinstall in the reverse order.
1
130BC077.10
Illustration 8.16
1 Fan
Table 8.16
I-Frame Size Disassembly an...
VLT
®
HVAC Basic Drive Service Manual
84 MG90X202 - VLT
®
is a registered Danfoss trademark
88