Service manual

8.3.5 Bus Bar

1. Unplug and remove the red/black cable.

2. Remove the black plastic cover.

3. Remove 8 screws (T20) from the support bracket.

4. Remove the bus bar assembly.

Reinstall in the reverse order.

130BC073.11

Illustration 8.13

1 Bus bar

Table 8.13

8.3.6

RFI Filter

1. Unplug the 3 filter cables from the thyristors

using a hex 8 key.

2. Loosen the 3 cables from the cable connector

using a hex 5 key.

3. Remove 3 screws (T20) from the support bracket.

4. Remove support bracket.

5. Remove 4 screws (T20) from the RFI Filter.

6. Remove the entire assembly.

Reinstall in the reverse order.

130BC076.11

Illustration 8.14

1 RFI filter

Table 8.14

I-Frame Size Disassembly an...

VLT

HVAC Basic Drive Service Manual

MG90X202 - VLT

is a registered Danfoss trademark 83

8 8