Service manual

8.2.2 Cable Mounting Plate

1. Remove the ribbon cable.

2. Remove 1 screw (T20) from shield metal.

3. Use a flat screwdriver to release the retainers and

connection terminals.

4. Use a hex 4 key to loosen the screws in the cable

connector.

5. Pull out the cables.

6. Slide the connector to the side and remove it.

7. Remove 2 screws (T20) from the mounting plate.

Reinstall in the reverse order.

130BC060.11

Illustration 8.2 Cable Mounting Plate

1 EMC shield

2 Cable mounting plate

Table 8.2

8.2.3

Heatsink Fan Assembly

1. Unplug cable from power card.

2. Remove 2 screws (T20) from the fan mounting

plate.

3. Push the cable downwards. Use a screwdriver to

press the gasket down through the entry.

4. Pull out fan assembly.

Reinstall in the reverse order.

130BC064.11

Illustration 8.3 Heatsink Fan Assembly

1 Fan cover

2 Fan assembly

Table 8.3

I-Frame Size Disassembly an...

VLT

HVAC Basic Drive Service Manual

MG90X202 - VLT

is a registered Danfoss trademark 77

8 8