Service manual

7.5.9 DC Coil
1. Remove the 4 screws (T20) from the DC coil
cover plate.
2. Remove the 4 screws (T20) from the heatsink.
3. Remove the heatsink.
4. Remove 4 screws (T20) from each of the 2 DC
Coils.
5. Remove the coils.
Reinstall in the reverse order.
1
2
3
130BC133.12
Illustration 7.24 DC Coil
1 DC coil cover plate
2 Heatsink
3 DC coil
Table 7.24
7.5.10
Capacitor Bank
1. Remove the foil.
2. Remove the 4 screws from the bottom plate.
3. Remove the bottom plate.
4. Remove the 4 screws from the capacitor bank
assembly.
5. Remove the assembly.
6. Turn the assembly upside-down.
7. Remove the 2 hex nuts with a hex 19 key.
8. Remove the 2 capacitors.
Reinstall in the reverse order.
130BC348.10
1
2
3
Illustration 7.25 Capacitor Bank
1
Foil
2 Bottom plate
3 Capacitor bank
Table 7.25
H-Frame Size Disassembly a...
VLT
®
HVAC Basic Drive Service Manual
72 MG90X202 - VLT
®
is a registered Danfoss trademark
77