Service manual

7.5.3 Inrush Card

1. Remove the 4 screws (T20) from the power card

mounting plate.

2. Remove the power card mounting plate.

3. Unplug all cables from the inrush card.

4. Remove the 6 screws (T20) from the inrush card.

5. Remove the inrush card.

Reinstall in the reverse order.

130BC346.10

Illustration 7.18 Inrush Card

EMC shield

2 Power card mounting plate

3 Inrush card

Table 7.18

7.5.4

Rectifier Modules

CAUTION

Wear protective gloves when cleaning up the thermal

paste as it is poisonous.

1. Remove cables and foil.

2. Remove coil cords (T20).

3. Remove 6 screws (T25).

4. Remove screws in coil cables (T20).

5. Remove the 6 screws (T25) from the bar.

6. Remove the bar.

7. Loosen and remove the 3 cables using a hex 10

key.

8. Remove the plastic cover.

9. Remove the 2 screws (T20) on each of the

rectifier modules

10. Remove the thermal paste paper.

11. Clean up any excessive thermal paste.

Reinstall in the reverse order. Join the mounting snaps.

H-Frame Size Disassembly a...

VLT

HVAC Basic Drive Service Manual

68 MG90X202 - VLT

is a registered Danfoss trademark