Service manual

130BC108.11

Illustration 7.16 Control Card and Control Card Mounting Plate

LCP

2 Cradle

3 Control card

4 Control card mounting plate

Table 7.16

7.5.2

Power Card

1. Remove 2 screws (T20) from the EMC shield.

2. Remove cables from EMC shield.

3. Remove the EMC shield.

4. Remove the LCP ribbon cable from the power

card.

5. Unplug all other cables from the power card.

6. Remove the 3 screws (T20) from the mounting

plate.

7. Remove the power card by pushing in the 6

retaining clips.

NOTE

Use a screwdriver if the retaining clips are hard to reach.

8. Slide the power card out and remove it.

Reinstall in the reverse order.

130BC125.11

Illustration 7.17 Power Card

Power card

Table 7.17

H-Frame Size Disassembly a...

VLT

HVAC Basic Drive Service Manual

MG90X202 - VLT

is a registered Danfoss trademark 67

7 7