Service manual

7.4.4 RFI Filter

1. Remove the red/black cables from the filter cable.

2. Remove the protective foil.

3. Remove the 3 filter cables screws using a hex 8

key.

4. Remove the 2 screws (T20) from the EMC shield.

5. Remove the EMC shield.

6. Remove the 8 screws (T20) on the filter cable

cover.

7. Loosen the left cable connector using a hex 5 key

8. Remove the entire filter assembly.

Reinstall in the reverse order.

130BC126.11

Illustration 7.10 RFI Filter

1 RFI filter

2 Screws

3 EMC shield

Table 7.10

7.4.5

Relay Transducer Card

1. Unplug cables on the relay transducer card.

2. Loosen the right cable connector using a hex 5

key.

3. Open the plastic clamp to remove the cables

from the connector.

4. Remove the 2 screws (T20) from the holding

bracket.

5. Remove the holding bracket.

6. Remove the 3 cable screws (T20).

7. Remove the 3 screws on relay card (T20).

8. Remove the Relay card by pushing in the

retaining clips on the standoffs. Use a screwdriver

if necessary.

9. Remove the mounting plate.

Reinstall in the reverse order.

130BC127.11

Illustration 7.11 Relay or Transducer Card

1 Relay transducer card

2 Relay card mounting plate

Table 7.11

H-Frame Size Disassembly a...

VLT

HVAC Basic Drive Service Manual

MG90X202 - VLT

is a registered Danfoss trademark 63

7 7