Service manual

7.4.2 Power Card

1. Remove the LCP ribbon cable from the power

card.

2. Unplug all other cables from the power card,

including the 3 gate cables at the bottom of the

card.

3. Remove the 3 screws (T20) from the mounting

plate.

4. Remove the power card by pushing in the 6

retaining clips.

NOTE

Use a screwdriver if the retaining clips are hard to reach.

5. Slide the power card out and remove it.

Reinstall in the reverse order.

130BC125.11

Illustration 7.8 Power Card

Power card

Table 7.8

7.4.3

Inrush Card

1. Remove the 2 screws (T20) from the filter shield.

2. Remove the shield.

3. Remove the 4 screws (T20) from the power card

mounting plate.

4. Remove the power card mounting plate.

5. Unplug all cables from the inrush card.

6. Remove the 6 screws (T20) from the inrush card.

7. Remove the inrush card.

Reinstall in the reverse order.

130BC346.10

Illustration 7.9 Inrush Card

EMC shield

2 Power card mounting plate

3 Inrush card

Table 7.9

H-Frame Size Disassembly a...

VLT

HVAC Basic Drive Service Manual

62 MG90X202 - VLT

is a registered Danfoss trademark