Service manual

7.3.5 RFI Filter

1. Remove the protection cover.

2. Remove the 6 distance bushes.

3. Remove the 2 screws on the frame side.

4. Remove the 3 screws from U V W cables.

5. Press the barbs on the side of the filter.

6. Remove the RFI filter.

Reinstall in the reverse order.

130BC111.11

Illustration 7.5 RFI Filter

RFI filter

2 EMC shield

Table 7.5

7.3.6

Power Card

1. Remove the 3 screws on the U V W cable

connector.

2. Remove the connector.

3. Remove the 3 small screws (T10) from the power

card.

NOTE

If it is difficult to get out the screws, use a magnet.

4. Remove the 6 remaining screws (T20).

5. Lift the power card and slide it out of the frame.

Reinstall in the reverse order.

NOTE

If it is difficult to remove the power card, it is helpful to

press the frame sides outwards while pressing the barbs

on the side of the power card.

130BC112.11

Illustration 7.6 Power Card

1 Power card

2 Power card mounting plate

Table 7.6

H-Frame Size Disassembly a...

VLT

HVAC Basic Drive Service Manual

60 MG90X202 - VLT

is a registered Danfoss trademark