Instruction manual

Cascade Controller Option
This display mode shows three operating data values
in the top line programmed via parameters 007,
008, and 009. Pressing the [DISPLAY MODE] key
toggles between Display modes I and II.
175ZA685.10
50.0Hz
SETUP
1
AUTO REMOTE RUNNING
100% 7.8A 5.9kW
Display mode III
Press and hold the [DISPLAY MODE] key while in Mode
II. Mode III is visible as long as the key is depressed.
The top line changes to identify the data names and
units displayed. Lines 2 and 4 are unchanged. When
the key is released, the display returns to Mode II.
175ZA686.10
60.0Hz
SETUP
1
AUTO REMOTE RUNNING
REF% CURR.A.POW.,KW
Display mode IV
This display mode is used for local operation, where
the local speed reference is given from the keypad.
In this display mode, the reference is determined via
the [+] and [-] keys. Control is carried out through the
bottom keys on the keypad. The first line indicates
the required reference. The third line gives the relative
value of the output frequency in the form of a bar
graph in relation to the maximum frequency.
175ZA688.10
40.0Hz
HAND LOCAL RUNNING
USE +/- 40Hz
■ Changing data
Regardless of whether a parameter has been selected
under the Quick Menu or the Extend Menu, the
procedure for changing data is the same. Pressing
the [CHANGE DATA] key gives access to changing
the selected parameter. Line 3 displays the parameter
number and title. The underlined function or number
flashing in line 4 on the display is subject to change.
The procedure for changing data depends on
whether the selected parameter represents a
numerical data value or a function.
C
hanging numeric values
If the chosen parameter represents a number value, the
flashing digit can be changed by means of the [+] and [-]
keys. Position the cursor by using the [<] and [>] keys,
then change the data value using the [+] and [-] keys.
The selected digit is indicated by a flashing cursor.
The bottom display line gives the data value that
will be entered (saved) by pressing the [OK] button.
Use [CANCEL] to ignore the change.
175ZA687.10
24.2 Hz
SETUP
1
FREQUENCY
205 MAX. REFERENCE
000060.000 Hz
6
Changing functional values
If the selected parameter is a functional value,
the selected text value can be changed by
means of the [+] and [-] keys.
175ZA689.10
3.90 A
SETUP
1
210 REFERENCE TYPE
SUM
MOTOR CURRENT
The functional value flashes until signing off by pressing
the [OK] button. The functional value has then been
selected. Use [CANCEL] to ignore the change.
C
hanging listed numeric values
A few parameters offer numeric lists of values that can
be selected from or changed. This means that if the
numeric value is not listed, a value may be entered
using the procedure for changing numeric values. This
applies to parameter 102, Motor power, parameter 103,
Motor voltage, and parameter 104, Motor frequency .
MG.60.I5.22 - VLT is a registered Danfoss trademark
27
User
Interface