Instruction manual

Cascade Controller Option

■ 12. Remove Wiring Clamp Mounting Fixture

• Option card insulation pad is designed to use top

most cable wiring clamp screw hole for attaching.

• Use screw driver to remove top most wiring clamp.

■ 13. Reconnect AFD Control Terminals and

Secure Option Card InsulationPad

• Reconnect AFD control terminals removed in

step 2 by pressing firmly into corresponding

terminal socket.

• Crease option card insulation pad flap and in

sert

into slot in side of control card cassette.

• Attach insulation pad to top most clamp position

with one screw from removed wiring clamp.

• Route AFD control terminal wiring through bottom

left wiring clamp and fasten.

■ 14. Final Reassembly

• Secure access cover to internal AFD components.

• Replace LCP keypad by positioning guide slots at

bottom of cradle and snapin

g into place.

• Attach terminal protective cover by positioning

guide pins at bottom of cover into control card

cassette and snaping into

place.

MG.60.I5.22 - VLT is a registered Danfoss trademark

Installation and

Wiring Instructions