Instruction manual

Cascade Controller Option

■ 5. Cascade Option Card Ribbon Cable Routing

• Route ribbon cables from cascade controller

option card through slot at side of AFD control

board cassette. Option card mounts with

component side down.

• Feed plastic option card insulation pad through

terminal opening in control board cassette.

• Insert edge of option card into slot (A)

in side of cassette.

• Align opposite side of card with mounting

holes (B) provided.

■ 6. Secure Option Card

• Secure option card to control board cassette with

3 self-tapping screws and washers provided.

Use a Torx T-10 screw driver.

MG.60.I5.22 - VLT is a registered Danfoss trademark