Instruction manual

Cascade Controller Option
■ 1. Access to Control Card Cassette
• Remove Local Control Panel (LCP) keypad by
pulling out from top by hand. LCP connector
on panel back will disconnect.
• Remove terminal protective cover by gently
prying with screw driver at top notch and lift
cover out of guide pin fittings.
• Open access cover to internal AFD components.
(Drive configurations vary.)
■ 2. Disconnect AFD Drive Control Wiring
• Remove control wiring by unplugging
connector terminals.
• Remove wiring clamp by removing two
screws. Save for reassembly.
• Loosen two captive screws securing control
board cassette to AFD chassis.
MG.60.I5.22 - VLT is a registered Danfoss trademark
10