Operating instructions

VLT
®
5000 FLUX
■ Operation and Display
■ Introduction
The parameter group 001 - 099 provides the adjustment and settings for the operation site and for the
operation and settings of the LCP (Local Control Panel) display and storing unit.
PNU Parameter Factory setting Range Changes 4-Setup Conversion Data
# description during operation index type
001 L
Language
English No No 0 5
002 L
Local/remote control
Remote control Yes Yes 0 5
003 L
Local reference
000.000 Yes Yes -3 4
004 A
Active setup
Setup 1 Yes No 0 5
005 P
Programming setup
Active setup Yes No 0 5
006 C
Copying of setups
No copying No No 0 5
007 L
LCP copy
No copying No No 0 5
008 D
Display scaling speed
1 0.01 - 100.00 Yes Yes -2 6
009 D
Display lini 2
Speed [rpm] Yes Yes 0 5
010 D
Display line 1.1
Reference [%] Yes Yes 0 5
011 D
Display line 1.2
Motor current [A] Yes Yes 0 5
012 D
Display line 1.3
Power [kW] Yes Yes 0 5
013 L
Local operation mode
LCP control Yes Yes 0 5
014 L
Local stop
Enable Yes Yes 0 5
015 L
Local jog
Not possible Yes Yes 0 5
016 L
Local reversing
Not possible Yes Yes 0 5
017 L
Local reset of trip
Possible Yes Yes 0 5
018 L
Lock for data change
Not locked Yes Yes 0 5
019 O
Operating state at power-up, local
control
Forced stop, use
saved ref.
Yes Yes 0 5
024 U
Userdefined Quick Menu
Not active Yes No 0 5
025 Q
Quick Menu Setup
000 0-999 Yes No 0 6
Changes during operation:
"Yes" means that the parameter can be changed,
while the frequency converter is in ope
ration. "No"
means that the frequency converter must be stopped
before a change can be made.
4
-Setup:
"Yes" means that the parameter can
be programmed
individually in each of the four setups, i.e. the
same parameter can have four different data
values. "No" means that the dat
avaluewillbe
the same in all four setups.
C
onversion index:
This number refers to a conversion figure to
be used when writing or read
ing by means
of a frequency converter.
Conversion index Conversion factor
74 0.1
2100
110
01
-1 0.1
-2 0.01
-3 0.001
-4 0.0001
Data type:
Data type shows the type and length of the telegram.
Data type Description
3Integer16
4Integer32
5Unsigned8
6Unsigned16
7Unsigned32
9Textstring
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.55.A7.02 - VLT is a registered Danfoss trademark
60