Operating instructions

VLT
®
5000 FLUX
Appendix
PNU Parameter Factory setting Range Changes 4-Setup Conversion Data
# description during operation index type
400 B
Brake function/overvoltage control
Off Yes No 0 5
401 B
Brake resistor, ohm
Depends on the unit Yes No -1 6
402 B
Brake power limit, kW
Depends on the unit Yes No 2 6
403 P
Power monitoring
Warning Yes No 0 5
404 B
Brake check
Off Yes No 0 5
405 R
Reset function
Manual reset Yes Yes 0 5
406 A
Automatic restart time
5 sec. 0 - 10 sec. Yes Yes 0 5
409 T
Trip delay torque
5 sec. 0 - 60 sec.
417 S
Speed PID proportional gain
0.015 0.000 - 5.000 Yes Yes -3 6
418 S
Speed PID integration time
200 ms 2.00 - 20.000
ms
Yes Yes -4 7
421 S
Speed PID low-pass filter
5/20 1-500 ms Yes Yes -4 6
445 F
Flying start
Disable Yes Yes 0 5
458 L
LC-filter connected
No 0-1 No Yes 0 5
459 C
Capacity LC-filter
2 μF 0.1-100 μF No Yes -1 6
460 I
Inductance LC-filter
7 mH 0.1-100 mH No Yes -1 6
462 S
Saturation brake
Off 0-100% Yes Yes 0 6
463 A
AEO Cos Phi
0.91 = OFF 0.50-0.91 Yes Yes -2 S16
470 A
Adaptive Gain Scale
100% 20%-500% Yes Yes 0 U16
471 A
Adaptive Gain min speed
50 RPM 0-1500 RPM Yes Yes 67 U16
472 A
Adaptive Gain max speed
50 RPM 0-1500 RPM Yes Yes 67 U16
MG.55.A7.02 - VLT is a registered Danfoss trademark
137