Technical data

50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
09.0 HZ
The selected digit can then be changed infinitely vari-
ably using the [+ / -] keys:
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
10.0 HZ
The chosen digit is indicated by the digit flashing. The
bottom display line shows the data value that will be
entered (saved) when signing off with [OK].
Manual initialisation
NB!
Manual initialisation is
not possible on the
LCP 2 175N0131 control unit. It is, how-
ever, possible to perform an initialisation
via par. 620 Operation mode:
The following parameters are not set to zero when in-
itialising via par. 620 Operation mode.
- par. 500 Address
- par. 501 Baud rate
-
par. 600 Operating hours
- par. 601 Hours run
-
par. 602 kWh counter
- par. 603 Number of power-ups
- par. 604 Number of overtemperatures
- par. 605 Number of overvoltages
-
par. 615-617 Fault log
VLT
®
2800 Series
36 MG.27.E3.02 - VLT
®
is a registered Danfoss trademark