Technical data

The alarm output can also be configured via the integrated Web Server. For details, refer to the
Web Server User Manual.
8.3.3. Communication Channel
This menu item is available for TLX CN Pro and TLX CN Pro+ only.
Selection of a communication channel is the first step in configuration of email transmission and
FTP upload.
To select communication channel:
Use the display of the master inverter.
Go to [Setup Communication setup Communication channel].
Select ‘GSM’ to transmit FTP upload and emails via the optional GSM modem.
Select ‘Local network’ to transmit FTP upload and emails via Ethernet.
To fully activate email communication or FTP upload, additional configuration is required in the
menus [GPRS connection setup] and [Data Warehouse Service].
Note that when the communication channel is set to 'Not present', no FTP upload or email
transmission will take place, even when parameters are configured correctly in [GPRS connec-
tion setup] and [Data Warehouse Service].
8.3.4. GSM modem
Refer to the GSM Manual.
8.3.5. RS485 Communication
The configuration of the RS485 network interface consists of 3 parameters in the menu [Setup
Communications setup RS485 setup] (requires a security level 1 or higher):
Network
Subnet
Address
Note:
The inverter is pre-configured with a unique RS485 address. If the address is changed man-
ually, ensure that inverters connected in a network do not have identical addresses.
8.3.6. Ethernet Communication
Refer to the section
Auxiliary Interface Specifications
for Ethernet communication configuration
details.
8.4.
Start-up and Check of Settings
Note:
Due to the advanced functionalities of the inverter, it may take up to 10 seconds before the
display becomes available after power up.
8. User Interface
L00410582-01_02 71
8