Installation manual

Appendix
264 of 268 Solar-Log
1000/500/200
Installation
Interconnection of Kaco Powador inverters
Figure 16: Interconnection of Kaco Powador inverters
Instructions for Powador 6400xi and 8000xi
 Interconnection of Powador 6400Xi and 8000xi:
 Set 1 inverter as “Master”, 2 as “Slaves”;
Read the labelling on the inverter circuit board!
 Clamp the Solar-Log™ data cable to the “LOGGER” terminal strip on the
Master inverter
 Also connect the inverters to each other through the “SYM” terminal strip
 Connect any additional inverters through the “Logger” terminal strip
 On the inverter operating display: Set the communication addresses,
numbering consecutively
 On the inverter operating display: Switch “SYM Bus” to active
 Powador 6400Xi and 8000xi stand-alone mode:
 Set the inverter to “Slave”, irrespective of labelling on the circuit board
 Clamp the Solar-Log™ data cable to the “SYM Bus” terminal strip
 On the inverter operating display: Switch “SYM Bus” to inactive
 On the inverter operating display:
Set the communication addresses, numbering consecutively