Operation Manual

GB - Commissioning Instructions

Thermostat (refer to page 3 for thermostat type)

Step 1. Type A Press & hold buttons  and + for 3 seconds

Type B Press & hold LEARN button for 3 seconds

Type C Remove dial, press & hold LEARN button for 3

seconds (located under setting dial)

Do not replace knob until Learn process is complete

NOTE: Thermostat now transmits continuously for 5 minutes.

Receiver

Step 2. RX1

Press and hold buttons PROG and CH1 for 3 seconds

until green light  ashes

Step 3. RX2 /

RX3 (if applicable)

Stat 1 - perform steps 1-2 for CH1

Stat 2 (RX2 & RX3)

Wait 5 mins, perform step 1, then press

PROG + CH2 on RX2/RX3

Stat 3 (RX3 only)

Wait 5 mins, perform step 1, then press

PROG + CH3 on RX3

Use only

during

programming

Receiver status

LED,  ashes when

receiving

Emergency ‘ON’ button, press

if communication fails, turns

on heat, returns to AUTO when

communication is re-established.

Zone status

LEDs, lit when

‘ON’

Commissioning Instructions