Installation Guide

© Danfoss | Climate solutions | 2021.07
AN383426363919en-000101 | 8
Step 05: Highlight and select, then scroll up and down to select CAN ID address number and press return
Further information about using the MMI can be found in the MMI instruction guide: Link
Further information about functionality and using the menus can be found in the EKE 400 datasheet: Link
Fig. 14 MAN SELECTION
Fig. 15 CAN ID
Step 04: Next, highlight and select (return ↵ button) “MAN SELECTION”
Navigating the front door display
The front door HMI gives an overview of the system status and can easily be navigated via the arrow buttons. The displays give us
easy to understand information about the:
• Active alarms
• The status of each evaporator
Fig. 16
Navigating from controller to controller is explained in the previous section. Other instructions regarding controller/evaporator
information that may be viewed can be found on the EKE 400 datasheet: Link