User Guide

ManualsBrandsDanfoss ManualsDigital ActuatorsDanfoss NovoCon M Digital Actuators

AQ291838446552en-010501 | 1© Danfoss | 2021.09

NovoCon® M

Operating Guide

NovoCon® M + NovoCon® M + NovoCon® M +

AB-QM NovoCon AB-QM NovoCon AB-QM NovoCon

(DN 40/50) (DN 50) (DN 65-100)

NovoCon® M / 73697030

④

⑤

⑥

Click

②

①

③

◯

②

③

◯

③

⑥

Click

④

⑤

◯

❶

Summary of content (4 pages)

PAGE 1
Operating Guide NovoCon® M / 73697030 NovoCon® M NovoCon® M + AB-QM NovoCon (DN 40/50) NovoCon® M + AB-QM NovoCon (DN 50) NovoCon® M + AB-QM NovoCon (DN 65-100) ❶ ⑥ ◯ A ① ③ ⑤ ② Click ④ ⑥ ◯ B ③ Click 1a ◯ ③ © Danfoss | 2021.
PAGE 2
NovoCon® M ❷ ① ② ③ ④ ⑤ +24V 0V A+ B− GND T3 24V AC/DC BACnet MS/TP or Modbus RTU Temperature sensor 3 R on R off T2 T1 GND GND AO AI Temperature sensor 1 Analog output Temperature sensor 2 Analog input GND is common for all signals ❸ NovoCon® M 003Z8540 E100 VXX 01 281624 0030471 Actuator for AB-QM DN40-100 Control signal: BACnet MS/TP, Modbus RTU, 0-10V, 0-20mA Serial number and QR code can be removed from the NovoCon® M label and added to installation drawing.
PAGE 3
NovoCon® M ❹ ❺ DIP Switch 1 2 3 4 5 6 7 8 R ON OFF Dip switches for addressing and bus protocol selection are located under the lid of the actuator. Dip switches 1 to 7 are used to assign the MAC address manually. Default MAC address assignment method is Auto MAC addressing for BACnet MS/TP and DIP Switches for Modbus RTU. Dip switch 8 is used to select between BACnet MS/TP (OFF=Default) and Modbus RTU (ON). When the protocol is changed on DIP Switch 8, a power cycle is required.
PAGE 4
NovoCon® M ❼ ④ ① ② ~ 60° Click ③ ⑥ ⑤ ⑧ ⑦ ❽ Safety Note Safety Note To avoid injury and damage to persons and devices, it is absolutely necessary these instructions are carefully read and observed prior to assembly and commissioning. Necessary assembly, start-up, and maintenance work must be performed only by qualified, trained and authorised personnel. Switch off the power line before wiring the actuator.