installation Guide

VISGL45X © Danfoss 04/2011
Resetting a device
Any device can be reset, the procedure is individual for each device. See individual device manual.
Removing a device
Remove the front cover and press the Set-Up pin for 3 seconds.
1. Select Rooms and Devices. 2. Select Manage Devices. 3. Select Remove any device.
If the device is to be replaced, remove the device from the system by
pressing Remove any device and then select the device to be
removed.
To add a replacement device just follow process described in
Modifying an existing installation 1: Adding devices to an existing
room (see page 9).
4. Delete dead device.
Installation Guide Danfoss Link™ CC - Modifying an existing installation
3: Removing / Resetting
a Room or a Service
device
4: Factory reset of
Central Controller
Remove the front cover and press the reset button, at right side of the Central Controller, until clear Beep
sound can be heard.
GB
13