Operating instructions

9.4.2 Input variables (nvi)

Variable Function Variable Name SNVT type Profile FC 100 par.

Start/Stop nviStartStop SNVT_switch FC VSD CTW/reference

Control word nviControlword SNVT_state FC VSD CTW

Reset fault nviResetFaut SNVT_switch FC VSD CTW

Reference [%] nviRefPcnt SNVT_lev_percent FC VSD Reference

Reference [Hz] nviRefHz SNVT_freq_hz FC VSD Reference

CL Setpoint 1 nviSetpoint1 SNVT_lev_percent FC VSD 20-21

CL Setpoint 2 nviSetpoint2 SNVT_lev_percent FC VSD 20-22

CL Setpoint 3 nviSetpoint3 SNVT_lev_percent FC VSD 20-23

Bus feedback 1 nviFeedback1 SNVT_lev_percent FC VSD 8-94

Bus feedback 2 nviFeedback2 SNVT_lev_percent FC VSD 8-95

Bus feedback 3 nviFeedback3 SNVT_lev_percent FC VSD 8-96

Digital/relay outputs nviDigiOutput SNVT_state_64 FC VSD 5-90

Analog output (42) nviAnOut1 SNVT_lev_percent FC VSD 6-53

Analog output (X30/8) nvi101AnOut1 SNVT_lev_percent FC VSD 6-63

Analog output (X42/7) nvi109AnOut1 SNVT_lev_percent FC VSD 26-43

Analog output (X42/9) nvi109AnOut2 SNVT_lev_percent FC VSD 26-53

Analog output (X42/11) nvi109AnOut3 SNVT_lev_percent FC VSD 26-63

Setting of RTC nviTimeStamp SNVT_time_stamp FC VSD 0-70

ECB option Mode nviECBMode SNVT_state FC VSD 31-00

ECB By-pass activation nviECBActivation SNVT_switch FC VSD 31-19

Parameter access command nviParamRequest UNVT_param_request FC VSD -

Drive speed setpoint nviDrvSpeedStpt SNVT_switch VSD 6010 CTW / Reference

Standard Node Object nviRequest SNVT_obj_request Node obj. -

9.4.3 Configuration properties (nci)

Variable function Variable name SNVT type Profile

FC 100

parameter

Max. motor speed [%] nciMaxSpeed SNVT_lev_percent VSD 6010 4-13

Min. motor speed [%] nciMinSpeed SNVT_lev_percent VSD 6010 4-11

Nom. motor speed [RPM] nciNmlSpeed SNVT_rpm VSD 6010 1-25

Nom. motor frequency [Hz] nciNmlFreq SNVT_freq_hz VSD 6010 1-23

Min. ramp-up time [s] nciRampUpTime SNVT_time_sec VSD 6010 3-41

Min. ramp-down time [s] nciRampDownTime SNVT_time_sec VSD 6010 3-42

Heartbeat time [s] nciSndHrtBt SNVT_time_sec VSD 6010 -

Max Send Time (Heartbeat) nciMaxStsSendT SNVT_elapsed_tm Node obj. -

Min Send Time (Inhibit timer) nciMinSendT SNVT_elapsed_tm Virtual obj. -

VLT® FC 100 LonWorks 9 Troubleshooting

MG.11.E2.02 - VLT

is a registered Danfoss trademark