Operating instructions

ManualsBrandsDanfoss ManualsMedia ConverterFC 100 Series

These variables contain the value allocated to the analog output terminal X42/7-11 of the

Analog I/O option

. The variable type is changeable with the

commissioning tool.

NB!

This variable is available only if the Analog I/O option (MCB 109) has been installed.

Setting of RTC

Variable

name:

SNVT

type:

Field:

nviTimeStamp SNVT_time_stamp Year Month Day Hour Minute Second

2000 -3000 0 - 12 0 - 31 0 - 23 0 - 59 0 - 59

Use this input to set the built-in Real Time Clock.

ECB Option Mode

Variable

name:

SNVT

type:

State:

nviECBMode SNVT_state Boolean 1 bit x 16

Controls the operation mode of the ECB option. The binary value of this variable is mapped directly into par. 31-00

Bypass Mode

[0] Drive

[1] Bypass

ECB Remote By-pass Activation

Variable

name:

SNVT

type:

State:

nviECBActivation SNVT_state Boolean 1 bit x 16

Controls the remote activation of the ECB option.

The binary value of this variable is mapped directly into par. 31-90.

[0] Disabled

[1] Enabled

NB!

This input variable applies only if the ECB option is installed in the frequency converter.

Parameter Access Command

Variable

name:

SNVT

type:

Value:

nviParamRequest SNVT_param_request

These input variables are used for for frequency converter parameter access.

For more information on parameter access, please refer to

How to Access FC 100 Parameters

section.

5 Configuration of the system VLT® FC 100 LonWorks

MG.11.E2.02 - VLT

is a registered Danfoss trademark