Operating instructions

Instructions:

- Remove LCP panel from the FC 100

- Remove the frame located beneath and discard

- Push the option into place. Two positions are possible, with cable terminal facing either up or down

- Push the fieldbus option adaptor frame for the FC 100 into place

- Replace the LCP and attach cable

- On A1 and A2 enclosures with cable terminal facing up: Fasten the cable onto the de-coupling plate (the FC 100 top surface has pre-drilled

threaded holes for attaching the de-coupling plate to the unit).

VLT® FC 100 LonWorks 4 How to install

MG.11.E2.02 - VLT

is a registered Danfoss trademark