Datasheet

© Danfoss | 2018.01 VD.DZ.F2.02 | 1
Atomizing Water Spray Nozzles Types M & MW
Data sheet
Application
Identification The nozzles are marked with the following
information:
MW 5
12345
Stamped on the flats
MW Water Spray Nozzle
M Mini
MW Mini Wide
5 Capacity 5 = 5 USgal/h at 100 psi (~ 7 bar) and 35 SSU (2.7 cSt)
12345 Batch code
Technical Data
Material and construction
Brass: Our common grade material of
construction. Acceptable for most water based
applications.
Type 416 stainless steel: Available on request.
Type 416 stainless steel shows good resistance to
wear at higher water pressures. It is rust resistant
as well, but not rust proof.
Pressure vs. Flow
For general purposes, changes in flow rate due
to changes in pressure can be estimated as being
approximately equal to the square root of the
pressure ratio.
Therefore: Flow rate at the desired pressure =
√
Hago Mini nozzles are widely used in both
professional and home green houses for plant
and seedling misting, in industry for process
cooling or humidifying and in agriculture for
livestock cooling. In recent years they have been
used in dry climates for home patio cooling.
Application and Features
• Misting, cooling, humidifying
• Spraying light oils
Availability
• M: 80° sprayangle at 100psi (~ 7 bar)
• MW: 160° sprayangle at 100psi (~ 7 bar)
• Spray pattern: Semi solid cone
• Available in 12 pieces box single packed or 50
pieces blister pack.
Mini nozzle type M features our unique perfect
solution where small size, accurate ow rates,
very ne atomization and low cost are desired.
Mini Wide nozzle type MW designates “wide
angle” and provides a very ne atomization in low
volume ow rates with a wide spray angle and
large coverage area.
Filtration
120 μm stainless steel filter.
Recommended tightening torque
100-150 in-lbs (11-17 Nm).
Maximum tightening torque
150 in-lbs (17 Nm).