Installation guide

AKM/AK Monitor/AK Mimic Installation guide RI8BP602 © Danfoss 10/2011 7
Button for Port Setup
The following settings are found behind the “Port” button:
AKM 5
(With the AKM 4, there is no choice of available channels on the right hand side. The AKM 4 has only
one channel of each type.)
AK monitor and MIMIC
List of possible channels:
AKM 4, AKM 5 AK-Monitor, AK-Mimic
AKA/m2 AKA/m2
AKA MDM
SM MDM
AKA TCP..
m2/Alarm
GSM-SMS GSM-SMS
AKA Winsock AKA Winsock
SM Winsock
SC Winsock
The various channels have the following settings:
• AKA/m2"
- Set Com port number.
- Baud rate (communication speed) to be set at 9600 (the factory
setting in the gateway is 9600 baud, and the PC and the gateway
must have the same setting value).
• MDM, Modem (only if modem is used).
- Set Com port number
- Set baud rate
- Set lifetime (the time the telephone line remains open if there is
no communication on the line)
- With a modem there is also an initiate string. This can be seen in
the field at the bottom left. It may be necessary to make changes
in this string, if the communication process is not satisfactory.
• AKA TCP/IP (only if Ethernet via Digi One is used)
- Select COM port to be used
- Keep baud rate at 9600
- Set IP address
- Set IP-GW address
- Set Subnet mask
- Check the addresses - particularly the IP address / write it down /
glue it to the converter! / DO IT NOW!!
- Push OK - the set addresses will now be sent to Digi One.
• m2/Alarm
(only if modem calls from one or more monitoring units type m2
with SW = 2.x is used).
- Select line m2 in the “Port Configuration” field
- Set Com port number
- Set Baud rate
- Set Lifetime
- Set Network address
- With the m2 communication there is an initiate string. It can be
seen in the field at the bottom left.
• GSM-SMS (only if a GSM modem (telephone) is connected di-
rectly to the PC’s Com.port).
- Select the line GSM-SMS in the "Port Configuration" field
- Set Com port no.
- Set Baud rate
- Set PIN code
- Indicate whether a startup SMS is required when the AKM
starts.
• WinSock
(only when Ethernet via the PC's net card is used)
- Select the actual WinSock line in the "Port configuration" field
- Select Host
- Set Lifetime
- Indicate TelnetPad if AKA-Winsock is to be used.
(The remaining information on the IP address is known by the
net card and becomes visible when the installation has been
concluded.)
Button for Router Setup (via AKA only)
(AKM 4 and 5 only)
The following settings are found behind the "Router Setup" but-
ton:
Here you set router lines for all the AKA destinations to which the
AKM programme is to send messages.
1 Set a net range
2 Set a Phone No or IP Address
3 Select Channel (Port) that is to transmit the message
(In AKM 5 there can be more than one channel for the same func-
tion. The number of channels was set in the picture "Port Setup".)
4 Select an initiation string in the "Initiate" field, if required (the
initiation string is shown/defined in the "Port Setup" display)
5. Push "Update"
6 Repeat the above for all destinations
7 Finish with "OK".
Receivers Telephone
number or IP address