Installation guide

AKM/AK Monitor/AK Mimic Installation guide RI8BP602 © Danfoss 10/2011 5
2. Installation of the programme on the PC
Procedure
1) Start Windows
2) Insert the CD-ROM in the drive.
3) Use the function "Run"
(select AKMSETUP.EXE)
4) Follow the instructions on the screen (the following section
contains additional information about the individual menu
points).
Setup display for AK-Monitor and AK-Mimic
Setup display for AKM 4 and AKM 5
The settings are explained on the following pages:
All settings only become active following restart.
Setup display
PC setup
Set the system address (the PC is given a system address, e.g. 240:124
or 51:124.
The addresses are taken from the example in appendices 2 and 3.
Show Communication trace
Indicators make communication with other units visible and trace-
able.
The port and channel that are communicating can be seen here.