Installation guide

AKM/AK Monitor/AK Mimic Installation guide RI8BP602 © Danfoss 10/2011 27
Appendix 3 - continued
Situation 4
Initial settings of AKC controllers in a plant from
a central PC
Objective
To make all the different settings in all AKC controllers via the AKM
Programme.
Conditions
• New installation of controllers
• A system setup, as explained in "Example 3".
Procedure
You may choose between two ways of setting the functions in the
controllers:
1. The direct way - where contact is established to the plant, after
which settings are made line for line (long telephone time).
2. The indirect way - where a file is first made in the AKM Pro-
gramme with all the settings, after which the plant is called and
the settings are copied into the controller.
Procedure to direct (1)
1. Activate the "AKA" - “Controllers” function.
2. Select the relevant network and the required controller.
3. Go through the function groups one by one, and select a set-
ting for all the individual functions. (If you are in doubt as to
how a function works, you can obtain help in the document
“Menu operation via AKM” for the relevant controller.).)
4. Continue with the next controller.
Procedure to indirect (2)
1. Activate the "AKA" - "Programming" function
2. Now select the standard file belonging to the controller to be
programmed.
3. Go through the function groups one by one, and select a set-
ting for all the individual functions. (If you are in doubt as to
how a function works, you can obtain help in the document
“Menu operation via AKM” for the relevant controller.)
4. When you have finished with the settings, the file has to be
saved, e.g. NAME.AKC
5. Activate the "AKA" - “Copy settings” function.
6. Push "File to AKC" and select the file in the “Source” field.
7. In the “Destination” field you indicate the network and address
of the controller whose values are about to be set. (The same
file may also be copied to other addresses, if the controllers
are of the same type and the software version is the same. But
beware if the controllers control other types of appliances,
other temperatures or other things that are different - check
the settings!).
8. Repeat points 1 to 7 for the next controller type.