Installation guide

AKM/AK Monitor/AK Mimic Installation guide RI8BP602 © Danfoss 10/2011 21
Introduction
This section will offer you guidance in various application
examples where you have to carry out installation work and
service on a system incorporating ADAP-KOOL
®
refrigeration
controls.
The various application examples are based on a setup where
certain requirements are mentioned that have to be met before
you start the procedure described below.
Remote serviceCentral PC
Plant
Plant
PC with AKM
PC gateway
Modem gateway
Modem
PC with AK Monitor
PC gateway
Modem gateway
Modem
Modem
Modem gateway
PC with modem
and AKM
Appendix 3 - Application examples (for AKA only)
The described procedure will be short and concise to enable you
to keep an eye on things the easy way, but you will be able to
obtain additional information in other documents.
The procedure will be very suitable as a checklist, if you are an
experienced user of the system.
The addresses used are the same as the ones used in Appendix 2.
Employed as basis in the various application examples are the
most commonly used installations, as follows: