Installation guide

AKM/AK Monitor/AK Mimic Installation guide RI8BP602 © Danfoss 10/2011 15
2. Select the description version in the remaining connected con-
trollers. Use AKA 21 for setting the language version in the AKC
controllers whenever possible.
3. Find this display via “Configuration” - “Upload”.
4. Click the "AKA" radio key
5. Enter network number under “Network”.
6. Select “Net configuration”.
7. Select "AKC description"
8. Push “OK” (this function may last a couple of minutes).
If the master gateway has been installed in such a way that a
pass-word is required, the password will be asked for at this
point. Enter the password, before you continue.
9. Store the loaded configuration. Push “Yes”.
All the texts from the various controller types will now be
loaded, and it will take several minutes for each type to be
loaded. In the “Information” field you can see the types that are
being obtained.
10. If there is contact with other front ends (AK-SM, AK-SC 255 or
AK-SC) points 3 - 9 must be repeated, although with:
a. Click the radio key = AK-SC
b. Key in Domain, Subnet and network, etc.
Later, when the programme has finished obtaining texts from the
various controllers, all the texts will be known by the programme,
and you may now proceed with a setup of the required
measurements.
Info
When a controller description has been sent to the AKM, it is this
description file that is used.
If a controller description is changed (e.g. an instruction from a control-
ler or an alarm priority) in a AK-SC 225, the following procedure must
be used before the AKM will recognise the change.
1. 1. Delete the actual description file in AKM using "Configuration" /
"Advanced configuration" / "Delete Description file
2. Start Upload function and send the new controller description to the
AKM.
BUT REMEMBER
If the AK-SC 255 settings are changed or a new upload is required
7. Resume
- The programme is now installed.
- There is communication to the different front-end which in turn
communi cates with the individual controllers.
- The controller texts and parameters are known by the pro-
gramme, so that the programme knows the settings and read-
outs that can be made.
- The next step is to define how these settings and readouts are to
be presented.
- Proceed with the Appendix in the AKM Manual: "Setup Guide
for AK-Monitor and AK-Mimic, or if you are an experienced user,
with the individual points found in the AKM Manuel.