Installation guide

14 Installation guide RI8BP602 © Danfoss 10/2011 AKM/AK Monitor/AK Mimic
Principle
A controller is defined with a code number and a software version.
This controller contains a number of data, e.g. with English text.
When the programme has just been installed, it does not know the
controllers that have been connected - but the different front-end
possesses this information. The information will be transferred to
the programme when the function “Upload configuration” is used.
The programme will first have a look at a defined network (DSN-
number). From here the programme loads infor mation about
the controllers (code number and software version) found in this
network and the addresses assigned to them. This setup is now
stored in the programme.
6. Upload controller data
Setting
Now that the system is able to communicate, an upload may be
made (Upload configuration) of the individual controllers’ texts.
1. If an AKC 31M unit has been installed, a description file must
be obtained from the supplied CD-ROM. Find this display via
“Configuration” - “Import Description file”.
Import one or more of the shown files.
If other description files are available from an earlier setup,
they must also be imported now.
The programme must now pick up all the texts pertaining to the
measurement values and settings for each controller type. AKC
31M texts must be obtained from the CD-ROM accompanying
the programme, and other texts from other controllers from the
data communication. When this has been accomplished, you have
obtained one standard description file for each controller type
and for the software version found in the network.
(“Upload configuration” is performed by selecting the field “AKC
description”).
Only now will the programme recognise all the possible settings
and readouts.
It may be helpful to add a name (ID) and a customer-adapted
choice of functions (Custom file).
The “MCB” field is for your information only, and so is the “Master
Control” function.