Installation guide
AKM/AK Monitor/AK Mimic Installation guide RI8BP602 © Danfoss 10/2011 13
4. Select the "AKA" / "Setup" menu from the AKM program.
Click on Router
Type address: 241:120
Click OK
241:120
Use the fields to set router lines for these two ports:
240 - 240 i RS232 (everything to 240 must be sent to the RS232
output)
241 - 241 - 125 in DANBUSS (everything to 241 must be sent to
the master on the DANBUSS output)
Then set the next gateway
Click "Router" and set address: 241: 125
Use the fields to set router lines for these two ports:
NET NUMBER - NET NUMBER IN RS232 + Phone No
241 - 241 - 0 in DANBUSS (own net = 0)
240 - 240 - 120 in DANBUSS
5. Once these settings have been made, the connection is ready.
The next step is to "see" what controllers are found at the plant.
This setting is covered in the next section.