User Guide

20
Sensor added!
If the user selected a new sensor to add, the sensor is added.
Setup Instructions
Cancel add sensor? Checking system
<------>
Add sensor: ID: 03ABC1
Add an extra sensor: From the installer menu select Change system. The system is searching for connected sensors. Press
to loop through the found new sensors or
to cancel add sensor. Press
when the correct new sensor to add is found or
“Cancel add sensor?” is selected.
13
Setup of ground system The installation of a GX™ 850 with 1 ground system has been selected. It is optional if the sensors are connected to the GX™ 850 before power on or during the installation.
The system uses the output System A.
If sensors for System A are not connected - do it now! Press
or wait…
System is being scanned to fi nd type of connected sensors… Select system type: Ground Wait until correct number of sensors for System A is found. Press
when all sensors are found…
System A is installed… System is being checked… Press
to confi gure System A.
(Naming sensors and changing factory settings) Please refer to “Changing parameters and performance of systems” in “User Manual” for description of the con- fi gurable parameters. If for some reason you do not wish to confi gure the system now you can press
to skip confi guration of
the system. Press
to end confi guration.
Connect sensors: System A System A Scanning... System type: Ground 3 Ground sensor found. Accept? System A! Installed Config system: System A Press  to end configuration.
Checking system
<------>
Setup Instructions