Brochure

6
When approaching obstacles (toilets, cabinets, etc.),
carefully remove some of the red heating cable
f r o m t h e m a t a n d l e a d t h e c a b l e
around the obstacle. In some cases pieces of the
grey mesh will be cut away entirely. Remember to never
cut the red cable. Use hot melt glue or a thin strip of tape
to secure the loose cable to the floor.
Step 5B. INSTALL THE LX MAT
An adhesive has been added to the bottom of the mat
which will prevent the mat from moving during
installation. Start by placing the mat such that the
connection point and the temperature sensor are in their
intended positions and bring the power cable to the
thermostat or connection box.
Begin unrolling the LX mat evenly across the floor
outside the areas that you marked previously.
The adhesive on the mat is made such that the mat may
be moved several times before it loses its
adhesiveness. When you reach the next wall, cut
the grey mesh, turn the mat, and begin rolling
in the desired direction.
NEVER CUT OR SHORTEN THE RED HEATING CABLE!
Ensure that the LX mat is in full contact with the
subfloor at all times. Avoid walking on the heating
mat. If this is not possible, use shoes with soft soles.
5B
Copyright 2009 Danfoss Inc.
TEL: [phone]. FAX: [phone]
088L3380 - 06/09