User`s guide

Operating the Zpen
Zpen User’s Guide
24
Tips – Important Facts to Know
 Please make sure to charge the device for 6 hours before using for
the first time. While charging, make sure the on/off LED is
blinking
 Please take care NOT to dismantle the pen’s crystal cone or
receiver
 To add a New Virtual Page, press the receiver’s clip button (at least
0.5 seconds). The pen LED indicator (middle light on the receiver)
will turn on for 0.5 seconds, indicating the creation of a New
Virtual Page
 The receiver will turn itself off automatically after being idle for 10
minutes
 When the receiver battery LED (far right LED) starts blinking, one
has up to 10 working minutes until the receiver will shut down.
Only after charging the receiver, will you be able to turn it on again
 Make sure the receiver is centralized on one of the paper’s edges
 The RESET button (small hole in the back of the receiver) should
be pressed in the following cases:
o Whenever the receiver is stuck (all LEDs are constantly on
or blinking)
o When the receiver is charged, the receiver turns off after
turning it on, or alternatively, the receiver doesn’t turn on
at all.