User`s guide

Operating the Zpen

Zpen User’s Guide

Step 3: Clip the Receiver to a Sheet of

Paper

The Receiver’s default position is on the top middle of an A4 or letter-sized

paper (or smaller) in portrait position. You can use any orientation (portrait

or landscape).

NOTE:

If you want to position the clip in a different location on the page, you must

modify the receiver’s position in the Multiplatform Viewer application

(ToolsÆSet receiver position) or in any other application

Attach the Receiver to a sheet of paper by pressing the white button (clip)

on the underside of the Receiver, and then insert a sheet of paper, a

notebook or a paper block.

Be sure to position the Receiver at the center of the chosen page edge (see

following drawing).

Step 4: Turn On the Receiver

To turn the Receiver on, press the On/Off button (the far left button on the

Receiver's front panel). The left and right LEDs will light up. Wait until the

power light turns red and stops blinking. This signals that the Receiver is

now ready to work with the Zpen.