Operating Instruction

ManualsBrandsDandong Dongfang Measurement & Control Technology ManualsElectronicsCustomer Premise Equipment

Operating Instruction of DF-CPE201 CPE

Thank you for your trust in DFMC. To operate properly, please read this instruction

carefully before using the product. In addition, please keep this instruction after

reading in case of future needs.

Operating Instruction of DF-CPE201 CPE

Introduction

DFMC is a high-tech enterprise specialized in R&D of mining vehicles GPS dispatching

system. Based on the accumulation of past experiences and the references of

international top-class technologies, with brand new product design, appearance

design and product functions, DFMC products has now been upgraded to fulfill all

kinds of open-pit mine applications.

I. About DF-CPE201 CPE

Power interface

Data interface

Antenna

Summary of content (4 pages)

PAGE 1
Operating Instruction of DF-CPE201 CPE Thank you for your trust in DFMC. To operate properly, please read this instruction carefully before using the product. In addition, please keep this instruction after reading in case of future needs. Operating Instruction of DF-CPE201 CPE Introduction DFMC is a high-tech enterprise specialized in R&D of mining vehicles GPS dispatching system.
PAGE 2
II. Aviation Plugs Sequence 1. Power interface: No. 1 Function GND 2. Network cable interface: No. 1 2 Function TX + TX orange, orange white 2 VCC 3 RX + green, white 3 N 4 Blue 4 N 5 Blue, white 6 RX – green 5 N 7 8 Brown, Brown white III. Parameters of DF-CPE201 CPE ⚫ 12~24V DC power supply ⚫ Speed limits: 515m/s ⚫ ⚫ ⚫ Operating temperature: -30℃~70℃ Dust-proof, shock-proof, low heat dissipation, 7/24 operation. Seismic factor: 5~300HZ, 5G accelerated impact IV.
PAGE 3
click ‘Load’ button. Reboot Click it to restart the equipment V. Cautions 1. After operation, the CPE power supply shall be shut down before electrical switches on the vehicle. On the contrary, the electrical switches shall be switched on before the CPE power supply. 2. The shovel is equipped with UPS. When shovel is shut down for maintenance, the CPE power supply shall be shut down before UPS (Switch off two switches on the UPS). After shovel maintenance, the UPS shall be switched on before CPE. 3.
PAGE 4
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.