Installation Guide

Instructions

Tools Required: Screw & Screwdriver (Not provided with kit)

1. Refer to your OEM instructions on how to safely remove the old floor register.

2. Remove your old floor register (A) and discard. Do not discard the old screws (B).

3. Measure your floor duct opening size (C).

4. Select the appropriate floor register for your need. Danco offers 4 different sizes.

Always choose a size slightly bigger than the duct opening itself. For example, if your

duct size is 3 ½” X 9 ¼” then choose the 4” width X 9 ¾” length (62068).

5. Install new register into your floor opening using the screws as shown on Image I.

Note: Some ducts don’t require the screws to hold register in place. If your duct opening

doesn’t have screw holes, then simply set the register into the floor opening.

6. Adjust the damper handle as desired.

INSTALLATION INSTRUCTIONS FOR

FLOOR REGISTER AND GRILLE

Danco, Inc., Irving, TX 75062

62067i/62068i/62069i/62070i

Danco Actual floor opening size Overall front size Depth

62067 4" width x 7-3/4" length 5-3/8" width x 9-3/8" length

5-3/8" width x 11-3/8" length

5-3/8" width x 10-1/8" length

5-3/8" width x 12-1/8" length

0.85"

62068 4" width x 9-3/4" length 0.85"

62069 4" width x 7-3/4" length 1.37"

62070 3-3/4" width x 9-7/8" length 1.37"

Image I

Damper Handles

Floor

Duct Opening

Width (C)

Duct Opening

Length (C)

Note: is dimension is what goes

into the oor duct opening

Overall front

size (Length)

Floor register

opening (Length)

Overall front

size (Width)

Floor register

opening (Width)