Instructions / Assembly

Figure A Figure B Figure C

Image I

2. REFER TO TABLE 1 ON PAGE 1 TO DETERMINE IF YOUR REPLACEMENT INVOLVES A LEFT FRONT, RIGHT FRONT, SIDE, OR ANGLED HANDLE PLACEMENT.

1. Remove existing handle

and arm. Loosen locknut

and pull entire arm

out through tank hole.

FOR RIGHT SIDE TOILETS:

RIGHT SIDE (PLASTIC HANDLE)

*Image shows Straight Lever Handle Style

Handle (A)

Locknut (C)

Red Button (E)

Lever Arm (D)

Lever Mount (B)

Image III

Use for Step 6

Image IV

Use for Step 6

Image VIIImage VI

Image V

Use Image III and Image IV for step 6

6. Position lever arm (D) perpendicular (90° Degrees)

to handle and slide back onto lever mount (B) using

arrows to align with notches; then twist to lock

in place. Lever arm (D) will be upside down with red

button pointing down when finished.

7. For angle adjustment (Image V) inside toilet, push up on red button (E) and lower lever arm (D) to adjust angle left or right and align placement

prior to connecting flapper chain.

8. For lever arm (D) height adjustment inside toilet (Image VI), push in toward lever mount (B) and rotate up or down.

9. Attach chain (Images VI and VII). Chain needs ½" slack with flapper closed. Arm cannot hit tank cover.

Use for Steps 4 through 5

Image II

3. Remove arm from packaging. Refer to Image I for how to hold the handle. Do not push red button marked X in Image I at this time.

With handle (A) facing towards you, push lever arm (D) in all the way as shown (Figure A, Arrow 1) and twist lever arm (D) 90˚ degrees as

shown (Figure A, Arrow 2) to align arrows on the back end of the lever arm with guides as shown in (Figure B) and thus

separating lever from handle mechanism (Figure C). Unscrew locknut (C) from handle mechanism (left-hand thread).

Use Image II for steps 4 through 5

4. Insert lever mount (B) through tank hole with the handle facing rear while ensuring the

T mark on the hub of the lever mount is facing up.

5. Reattach locknut (C) back onto lever mount (B) clockwise finger tight, ensuring locknut

is facing flat side toward handle.