Instructions / Assembly

ManualsBrandsDANCO ManualsPlumbingUniversal Decorative Toilet Tank Lever Handle in Oil Rubbed Bronze

Use for Steps 5 through 6

Image III

Use for Steps 4

Image II

Figure A Figure B

Image IV

Use for Step 7

Image VII

Image I

2. REFER TO TABLE 1 ON PAGE 1 TO DETERMINE IF YOUR REPLACEMENT INVOLVES A LEFT FRONT, RIGHT FRONT, SIDE, OR ANGLED HANDLE PLACEMENT.

1. Remove existing handle

and arm. Loosen locknut

and pull entire arm

out through tank hole.

FOR RIGHT FRONT TOILETS:

RIGHT FRONT (METAL HANDLE)

3. Remove arm from packaging. Refer to Image I for how to hold the handle. Do not push red button marked X in Image I at this time.

Use Image IV and Image V for step 7

7. Position lever arm (D) perpendicular (90° Degrees)

to handle and slide back onto lever mount (B) using

arrows to align with notches; then twist to lock

in place. Lever arm (D) will be upside down with red

button pointing down when finished.

Use Image III for steps 5 through 6

5. Insert lever mount (B) through tank hole with

the handle facing right while ensuring the T1

mark on the hub of the lever mount is facing up.

6. Reattach locknut (C) back onto lever mount (B)

clockwise finger tight, ensuring locknut is

facing flat side toward handle.

Use Image II for step 4

4. Holding the handle in your right hand with

the shaft pointing straight up, grab the

threaded hub portion of the Lever Mount (B)

with the other hand and pull apart (1),

compressing the spring at the end. Then

rotate the threaded hub (2) until T1 faces

up in the orientation it will be installed in

the tank. Release the threaded hub,

ensuring it seats fully back into the handle.

8. For angle adjustment (Image VI) inside toilet, push up on red button (E) and lower lever arm (D) to adjust angle left or right and align

placement prior to connecting flapper chain.

9. For lever arm (D) height adjustment inside toilet (Image VII), push in toward lever mount (B) and rotate up or down.

10. Attach chain (Images VII and VIII). Chain needs ½" slack with flapper closed. Arm cannot hit tank cover.

Hub of Lever

Mount (B)

Shaft

*Image shows Decorative Lever Handle Style

Handle (A)

Locknut (C)

Red Button (E)

Lever Arm (D)

Lever Mount (B)

Figure C

Image V

Use for Step 7

Image VI

Image VIII